Crossing/ HVT v5 Rebuildable Concentrate Heater pocket enail Developed with Humbolt vape Tech
Crossing/ HVT v5 Rebuildable Concentrate Heater pocket enail Developed with Humbolt vape Tech
Crossing/ HVT v5 Rebuildable Concentrate Heater pocket enail Developed with Humbolt vape Tech
Crossing/ HVT v5 Rebuildable Concentrate Heater pocket enail Developed with Humbolt vape Tech

Crossing/ HVT v5 Rebuildable Concentrate Heater pocket enail Developed with Humbolt vape Tech

Regular price
$75.00
Sale price
$75.00
Shipping calculated at checkout.

The V5 is finally here 

Kit Includes

  • complete v5 heater assembled( ready to go )
  • 1 extra side and bottom heated cup
  • 1 extra window for metal top
  • Dab tool
  • 4 extra screws, tool and orings
  • qtips and alcohol wipes
  • Directions

 

Instructions & Maintenance

Take Immediate Caution: 

Heater Cup Gets up to 600°f  and can cause serious burns. Please be careful when handling the unit.  Each part is replaceable, the whole unit can be rebuilt, there is no need to throw out the whole heater if one part breaks, we designed this with eco friendly concepts.

The v5 side and bottom heated ceramic cup with vortex airflow can be temperature controlled and is the most effective way to conserve and experience concentrates. Allowing maximum vapor at the lowest temps 

Take note battery/mod settings:

  • Wattage 27-37w Pulsing button
  • TCR Value 200 using 36w to get to 500°f 

Ultimately you will want to practice for the best experience. Some mods put out more power than others at the same settings. To preserve the side and bottom heated ceramic heater cups start on a low setting and work your way up to a happy middle ground of flavor and clouds.

 

             How to use:

Always keep your orings clean and lubed with a veg oil of your choice. This allows for the top to come on and off easier.  Place a small amount (2-5 hits max)of concentrate into the ceramic cup. Keep the unit upright through the whole session, do not tip or concentrate will pour out of the cup.    Press button on the mod to start heating the cup, allow concentrates to boil and vapor.   Now draw slowly, this will allow for maximum vapor and conserve concentrates in the cup from splashing out.  Be sure to maintain heat to cup so vapor is produced throughout the session.  Sessions should be no longer than 1 minute.  

Keep temperatures low enough from burning concentrates to a char(dry).  

Always q-tip the cup right after each session to maintain cleanliness and performance. Wipe down and clean the glass top while warm to avoid reclaim buildup in the pathway of vapor. Allow 3 minutes for the unit to cool down before the next session. 

Installing New Ceramic Cup

Under the right settings these cups should last a long time, when a heater cup goes out or the resistance rises you can replace it by unscrewing 2 of the screws that keep the cup’s lead wires fastened to the deck. Loosen screws then gently pull the cup out and remove.  

Every now and then you will want to burn off residue on the cup. Set the mod to 38w in wattage mode(this can be less for some mods, always start low and see) hold upside down while delivering only two minutes of heat to the cup. STOP allow it to completely cool off before next cleaning session. 

Please see the Divine Tribe Youtube channel for videos with instructions on how to use, clean, and rebuild the unit. 

 

 

 

add on a bottomless banger for an amazing enail experience in your current 14mm rig!!!