Now 3 versions! Classic or downward airflow in 14/18mm, or the Native Evo downward airflow adapter to use Evo or source orb glass!
With the 14/18 you can Use your Dr. Dabber Boost Evo with any rig or Hydratube with these 14mm and 18mm adapters! And The New Native adapter just fixes the airflow but still allows you to use your stock glass or any boost evo glass. This adapter also lets you use any Source orb versus glass with equal vapor production unlike the original design that has the airflow going over the bucket, not into the bucket where a carb cap would direct it to produce low temp vapor. This acts like a much needed carb cap for your evo! pulling the cool air and two the bottom of the bucket to vaporize at the lowest possible temperatures. You’ll find you never need to use the Evo above the lowest temperature again. In my opinion, it was actually tune too hot to compensate for the poor airflow path.
I’ve noticed a design flaw with the Evo. The air intake or “carb cap” on the magnetic quick connect comes in from the side and is not directed at the insert as it should be. On low “purple” temperature the Evo insert is hot enough to vaporize, but without the cold air stream like a carb cap delivers, tue oil doesn’t vaporize until it’s too hot. Just like hitting a banger without a carb cap, it doesn’t vaporize until the cool air hits it from the carb…unless you hit it hot which is what the Evo does. The Classic adapter helps this, the improved downward airflow adapter fixes this and makes it a much better device.
The Classic works similarly to the original Evo glass, except the walls are slightly longer to help direct the airflow slightly downward.
The New improved downward airflow adapter works as a much needed carb cap, directing the air intake into the bowl. Just remove the silicone from the quick connector and replace it with this 14mm or 18mm adapter. Point the large hole to the button and have the thickest clouds the Evo can make!
Or try the new native adapter if you want to use glass made for the Evo or source Orb! Just use your silicone seal from your magnetic adapter, put it on the native adapter and insert it into the magnet and you’ll have a big improvement from stock. Instead of having to burn your oil to get a hit, you’ll get huge clouds on the lowest setting just like the 14/18mm, but you can use your Evo Glass now!
Instructions
to use the downward airflow adapters you will take the silicone seal out of the magnet from the Evo and place it in the adapter as pictured. Then insert the adapter into the magnet.Make sure the arrow is lined up with the button. This will ensure the four holes for the air intake, match up with the adapter to force the air downward. Instead of sideways the adapter may be a little snug, but it needs to have a tight fit. If you have trouble, make sure you put it in straight down and you can always slightly warm it with a hairdryer to make it a little easier if you don’t feel like pushing on it hard.